Electrolube CPL200H 200ml Clear Protective Lacquer
Electrolube CPL is a general purpose colourless coating designed to protect printed circuit boards from environmental attack. The high gloss properties of CPL also make it an ideal choice for over-coating applications where cosmetics are a contributing factor. It is also suited for protecting ferrous metals from corrosion. CPL can be applied by spray, dipped or brushed. For full details including resistant tests please refer to the TDS below and if you still require further information then please do not hesitate to get in touch.
Features:
- No UV trace
- RoHS Compliant
- NATO Stock
- Can be soldered through
- Good resistance to humidity
- Ideal for protecting ferrous metals from corrosion
- Also used as a top coat for protecting conductive lacquers
- General purpose coating for PCBs giving high quality glossy finish
Specifications:
Liquid Properties:
- Appearance: Clear Pale Straw
- Density (at 20 degree Celsius): 0.86 g/ml (Bulk) , 0.79 g/ml (Aerosol)
- VOC Content: 79 percent
- Flash Point: 12 degree Celsius
- Solids Content: 21 percent
- Viscosity (at 20 degree Celsius): 25 mPas
- Touch Dry: 15-20 minutes
- Recommended Drying Time: 24 hours at 20 degree Celsius
- Coverage (at 25 µm): 7m2 per litre (Bulk), 1.3m2 (200 ml Aerosol)
Dry Film Coating:
- Colour: Colourless (High Gloss)
- Operating Temperature Range: -50 to 100 degree Celsius
- Co-efficient of Expansion: 140 ppm
- Dielectric Strength: 45 kV/mm
- Dielectric Constant: 3.5
- Surface Insulation Resistance: 1 x 1012 ?
- Dissipation Factor (at 1MHz at 25 degree Celsius): 0.01