DeWALT DCN692N 18 Volt XR Brushless Framing Nailer Body Only
DeWALT DCN692N 18 Volt XR Brushless Framing Nailer with brushless motor technology allows maximum run times when mated with 5Ah Lithium-ion Batteries. The sequential operating mode allows accurate placing and a bump mode provides superb production speeds, around 2 nails per second or 90 mm ring shank into C24 structural timber, DCN692N Nailers offer quick firing sequences, less recoil and durability when firing short nails. A fault indicator light communicates immediately why the nailer has failed to fire, low battery levels or nail jamming. These 18 volt DeWALT Nailers use a mechanical action rather than gas operated temperature does not affect the performance with reduced cleaning and service requirements. With a versatile 30 to 34-degree magazine angle DCN692N Nailers accept most clipped head and off centre round head paper tape collated framing nails.
Features:
- Two speeds - or power levels - to optimise the nailer for firing all lengths of nails
- Benefit from longer runtime, quicker readiness to fire, less recoil and more durability when firing short nails
- Brushless motor technology offers the power to fire a 90 mm Ring Shank nail in Soft Wood and 63 mm into Hard Woods
- The sequential operating mode allows for precision placement and the bump-operating mode provides the user with production speed
- Mechanical rather than gas operation offers consistent performance at temperature between -20 and 50 degrees Celsius and minimal cleaning/service requirements
- Class leading vibration and sound figures offer fantastic user protection
- Versatile 30 - 34 degree magazine angle will accept most clipped head, and off centre round head paper tape or wire weld collated framing nails
- Reversible belt/rafter hook provides increased portability and versatility on the job-site
- Depths can be easily adjusted using the thumb wheel depth adjuster
- Increased visibility and durability along with protection for work-surface from the non-mar contact-trip
- Ergonomic tool design allows the nailer to fit easily between a 400 mm centre stud
- Tool free stall/jam clearance minimises user downtime
- User can engage contact trip lock-off and prevent accidental discharge of fastener
- Dry fire lockout ensures that the tool is protected from firing without nails in the magazine